Ther is my new installation!! 12 panels (and 12 optimizers) facing south at 35º more or less. 5280Kwh of solar power. Solar Edge SE4000H connected via ModBus to the Cerbo Gx. Victron Multiplus II 48/5000, Smart Shunt 500 and EV Chargeing Station (allways working on automatic). All powered with a 10Kwh battery and the gird (normaly noy used only for export excedents). Certbo Relay 1 configured via Node-RED for control an aerothermia for hot water: if battery 96%, no battery consumption, and exporting at least 500w then start. With a 5 minut histerisis. Using an old tablet for a Gx Display on my living room. So proud to DIY all the installation!!
Just a little bothered by the fact that the gird and AC loads values keep fluctuating all the time in the GX Display… Especially the gird that goes from - to + contantly…
