Multiplus II power switch

DIY
, , , ,
1

Simple power switch question.

We have 6 Multiplus II units in parallel set to inverter only mode (DC to AC) and it seems like the power switch should be in the “ON” position. Instead they are all set to “charger only” and when I tried to move one of them to “ON” all power went out. Seems to be working, but setting doesn’t make sense.

  1. Leave them all set to “Charger only”?
  2. Switch them all to “ON” and wait for a reset?
  3. Switch them all to “OFF”, then after all are off switch them all to “ON”?
2

Or set the software switch on the GX to on, then change the physical switch , but yes. You can’t manually change one at a time.

3

So set the software switch to an and then move the physical switch to on.