Firmware 3.51 cerbo gx with Mopeka pro gassensors

Q&A and troubleshooting New UI
1

I am very excited about the new UI that comes with version 3.5x. I have 2 Mopeka pro gas sensors attached to my 2 LPG tanks. In the short overview I can see the complete percentage calculated for both tanks but in the level section I see both sensors separately although the fluid settings are both on LPG. Is there a possibility to also see the complete percentage LPG of both tanks instead of the separated values?

image
image478×274 12.2 KB

image
image793×620 18.5 KB

Greetings,
Nic

2

The system is working as designed. You can not make any changes to it. Perhaps future versions will have more customisation.

3

Hello, I do understand I can’t make any changes but I saw a Victron video in which this was possible with fuel tanks. I will search for it to show here :slight_smile:

Nic