Cerbo GX Venus OS v3.52-6 to V3.60~80 Temperature sensors scale and offset only in whole units

Beta testing Venus OS beta testing
, , ,
1

Hello,
I have the Cerbo GX with the latest large beta image.
I have installed some LM335 temp sensors, and notice I can’t set decimal numbers on scaling (not that i want to, but I noticed some other poster saying that to get farenheit output he could set scale to 1.8 and offset to 32 to get units in farenheit)

I would also like to set decimal numbers on offset, to tune the sensor more accurately.

I have Ruuvi sensor connected as well, and it reports the temp in decimals, ie 17.3 degree.
The hardwired sensors does not, I only see changes of whole degrees.
As it is now, the two sensors are in the same location, Ruuvi reports 17.3, while the LM335 reports 17. If I increase the temp half a degree, it is 17.8 vs 18.

Are there some fixes for this, official or otherwise? (SSH config is not foregin to me)

Regards,
Frode.

2

Hi @frojac , see my bug report. Until it is fixed, the Classic UI allows you to set the decimal number of the scale.

UI
UI741×503 114 KB

3

Hey both,

Sorry to have missed this one.

I’ll close it so we have one place: New UI - setting temperature sensor scale still present in V3.60~80

5

I have only just moved it to the beta category, it was originally posted in DIY.

1 Like