Cerbo GX no more unit front LED?

DIY
, ,
1

After updating to firmware v3.70, the LEDs on the front of the Cerbo GX no longer stay lit. I swear it used to glow blue or had continuous blinking. Now it only blinks after powering up (to test it) or if I cycle bluetooth off and on from the touch screen. Then it goes dark. But it never stays lit up or blinking continuously.

Is this normal?

2

Status LEDs toggled off became an option a few OS iterations back, I think. Lots of people were complaining about the LEDs blinking.

Check whether they’re toggled off in Settings > General > Demo Mode

LED
LED1038×209 20 KB

3

Thanks! I was a few iterations old on firmware so that explains it. As long as it’s normal, I’m good. Much appreciated.