Hey all, have figured out how to program the MP2 2x120 to dump the solar load when inverting, which works great. Problem is, to use that I have to turn off the VS, which then doesn’t turn AC2 in back on to feed the AC2 OUT loads when on shore power.
What assistant(s) do I need to program to allow AC2 In/Out to function normally when plugged into shore power, if the VS is turned off?
Still looking for some help here, squad!
MP2 2x120 set up for split phase when on shore power, marine application.
Turned of the VS to be able to program AC Out 2 to dump solar. Works great. Problem is with the VS off, the normal contact switchover to allow ACO Out 2 to function when shore power is connected isn’t functioning, despite an assistant programmed to turn AC Out 2 ON when AC1 is available for 60 seconds. What am I doing wrong?