Ik heb in mijn boot 2 huishoudaccus van 135 Ah parallel staan en een accu van 94 Ah voor de motor. De accu’s worden geladen door de dynamo via een Argofet laadstroomregelaar (200/2). De huishoudaccu’s worden ook geladen door zonnepanelen via een Victron SmartSolar MPPT 100/30. Kan ik de uitgang van deze regelaar ook aansluiten voor de laadstroomregelaar, zodat de motoraccu indien nodig ook geladen kan worden door de zonnepanelen? Dit om de zelfontlading bij langdurige stilstand te compenseren (winterperiode).
I’m not sure if your post is losing something in translation, but I assume that the ‘motorcycle’ battery is the 94Ah engine starter battery.
The MPPT unit can’t be connected to the common charge point of the Argo FET, as it then can lose the battery voltage reference.
In order to charge the starter battery from solar, you would need something like an automatic charge relay to connect the 2 sets of batteries in parallel when there is charge available.
The 94Ah battery is indeed the motorcycle battery. A follow-up question: Can I connect the motorcycle battery to the other battery without any problems? A connection will then be created between the two outputs of the Argo FET. Or do I need a relay that disconnect the ArgoFET from the motorcycle battery? (This situation will only occur if the engine is not running and the Argo FET is not active.)