Victron Lynx Shunt VE.Can M10 - Reverse Current Measurement

DIY
, , ,
1

Hello All,

The physical layout of my system required me to flip my busbar upside down, resulting in the batteries being on the RIGHT side of the Lynx Shunt VE.Can M10 and the loads being pulled from the LEFT side. As a result, my measurements are inverted from what they should be (charging shows discharging, & vice versa).

I looked at this thread (link) but it looks like the only option is to remove the cover and swap the orange & black wires; however, when I tried that, it didn’t detect current flow at all. It still read the voltage across the terminals, but no longer would show charge/discharge power.

Can someone help me figure out what I can do?

2

You have to swap black and green with orange.

With orange and green on the same side it can’t measure anything.

3

Do I need to do anything with the Red & White that are on the positive busbar?

4

As I wrote in the other topic:
I don’t think so, I guess it’s for detecting if the internal fuse is blown.

5

I am just using the dummy bar to bridge it.