I would like to make a point to Victron that the terminal connection sizes are too small and do not allow for larger cabling. This needs to be addressed and improved because it makes Victron less like a candidate in some of my Solar projects and though I like the quality of Vitron, I don’t like that…

What devices do you mean exactly?

@MP-Ranger normal lugs with 70qmm+ from Klauke or Cimpco do not fit the Lynx. Use the narrow “SG”-variant.

Mmmmm you can still use large cables you just have to get creative [image] 95mm2 in 10kVA Multiplus2 Q&A and troubleshooting @MikeD your ears must have been burning today as expletives came out of my mouth lol, well I finally got round to extending the inverter cable rep…

I was referring to the 12 V charge controllers for 40 A and 30 A the tiny little hex screws. Do not allow large enough cabling if you are using larger arrays on your camper or at your shop or at your hunting camp. If there are cable ends, that can be soldered or put over the cable with a smaller ni…

You mean the MPPTs? In the 30 and 50A models should fit 16 mm² (AWG6) and that should be enough as long as you keep the length below 3m (9,8 feet).

And what if you need it longer than 3 m? Not operated wires of the same quality either unfortunately so dimensions may vary.

Going all the way back to the year August 27 2020 on your own website the topic being: MPPT 75/15 wire terminal too small for 6mm² Or you could do a Google search on Victron solar charge controller terminals too small and get inundated with people complaining about it on different forums

See this from August 27, 2020 MPPT 75/15 wire terminal too small for 6mm²

[image] MP-Ranger: what if you need it longer than 3 m? Then you should try to change design and run the solar cable longer. (For efficiency reasons) As an FYI on the 75/15 mppt i have very comfortably installed then with 6mm cable both on the battery and the solar side.

Terminal connection size

DIY

Daza 24 May 2025 21:40 4

Mmmmm you can still use large cables you just have to get creative

Topic		Replies	Views
95mm2 in 10kVA Multiplus2 Q&A and troubleshooting expert , multiplus-ii , victron_community , lynx_distributor	20	617	10 February 2026
Multiplus 48/8000 cable gauge DIY beginner , multiplus	6	311	2 April 2025
Cable sizing question DIY diy , multiplus-ii , cerbo_gx	3	551	6 December 2024
MPPT connector specifications Q&A and troubleshooting diy , offgrid , mppt_controllers	10	1074	25 December 2024
Cable size for solar connection DIY beginner , mppt_controllers	4	110	25 August 2026

Terminal connection size

Related topics