I Should have given more information, i live in the netherlands. This means my meter does not care on which phase i charge or uncharge as long as the sum is near zero.
My roof is filled up with PV, the infeed will not go through the MP, so no changes there.
I would like 3xMP3000 of power(3x2,4KW), so i can charge my car at 7KW, remainder goes to the house. Also it can store all the PV energy the house does not consume. ( a single MP6500 will blow my mainfuse)
1: Is there a setting to power up only one MP3000 if there is little consumption to get maximum efficiency or do they always charge/uncharge at the same level?
@TomBerger, you are right, more battery will go a long way and also make sure the system works longer without replacing batterys, i was thinking of more than 20KWh. I have many days my infeed is in excess of 20KWh and the car will take it all in the evening.
2: Does anyone have any advise on brand or type’s of battery 48V i should look into?
3: Can i program the victron to charge/uncharge the battery between 30/100%?
My daily program will be the battery fills up with solar so my meter shows zero KWh, after dark the battery uncharges down to 30%, after that iam a normal consumer until the sun comes up again. 4: Any advice on the meter is should install near my main switch?
5: Does anyone see problem with this setup?