Multiplus 12/3000 120v No voltage on AC2 out

DIY
, ,
1

I am measuring 120 volts on my line in AC source. I’m reading 120v on my AC1 Output. I’m reading 0 on AC2 line.

How do I get AC2 to function. I though on this model it is pass through so when line voltage is present, it provides output. If line i land not present then it’s off.

AC1 works with shore power or battery as expected.

2

The two minute delay caught me. I was testing my non vital loads, nothing powered up, went into debug mode, then read about 100 posts and one mentioned a 2 minute delay. I waited anxiously, biting my nails, thinking all the worst! Then wala! Everything was fine!

I’ve sense retuned from the bathroom and all is good!

1 Like