I have a Bioenno 24 volt lithium battery ABS, BLF-2450AS and use it for a MinKota 24 volt Ulterra trolling motor I have a battery cable that runs from the negative terminal on the battery to the battery minus on the shunt. That is the only cable connected to the negative side of the battery. Every…

Your charged voltage is too low, if you have a current below 0.5% x 50 = 0.25A at the same time as the voltage is above 26.4V it syncs to 100% which happens every time you turn the motor off. Increase your charged voltage to something like 28.0V or 0.2V below your absorption charge voltage.

IP 65 500 AMP SmartShunt always returns to 100% SOC

DIY

pwfarnell 30 October 2024 09:32 6

There is a whole FAQ I wrote on this that I should have pointed you too if you want background reading.

shunt battery monitor jumping to 100…

Topic		Replies	Views
SmartShunt showing 100% when battery is not fully charged DIY diy , offgrid	21	4716	28 December 2025
SOC Victron Connect / Smart Shunt DIY victronconnect , beginner , lithium_battery	2	75	6 September 2025
SmartShunt showing 100% SOC when battery is not at 100% Q&A and troubleshooting victronconnect , diy , rv , smartshunt	8	253	27 October 2025
Smart Shunt SOC in linear fall despite charge cycles DIY diy , rv , vrm , smartshunt , campervan	10	153	6 June 2025
SmartShunt 300 not synced to batteries DIY smartshunt , smart_solar_charging	3	143	23 June 2025

IP 65 500 AMP SmartShunt always returns to 100% SOC

Related topics