I want to control the AC output 2 switch using modbus via Cerbo GX

Modifications
,
1

I have a Cerbo GX and inverters set up and connected via LAN all working well, I’ve established Modbus communications and have all points and control of a generator all working well. The only point I cannot locate in the modbus register is the address for is the AC2 output relay to be able to control via modbus read/write. Can any one assist please

Cheers and thanks in advance.

2

So far the workaround has been to use the aux or temp programmed on the inverter itself in an assistant to drive the relay and then using a cerbo relay to drive the aux/temp.
Programming the relay on the cerbo with the parameters wanted.

I could be corrected (very happily) but as far as i know it is not open on the modbus