Hello dear community, I have created simple (very simple) scheme of my planned victron 3 - phase home system. My questions are: Can I use only distributors or I need something else? or this is good as it is. every connection to busbar(distributor) is fused with fuse, is this ok? or should I al…

Hi! Late answer, but might help. Iam just building up a similar system. Question 1: Yes, I do the same Question 2: Fuses are needed to save cabling, if you don’t have some inside your Pylontech (I don’t know your “Pileo”(??translation?) (Max load ..Amps.. are normally controlled also by BMS… but …

I forget: You’re using 3 MPPT? I don’t know your Voc nor knowing your panel strings. Isn’t it cheaper to use a RS 450/100 or 200?? (instead of using 3 MPPT)?? A very good way to calculate is the very helpful Victron MPPT calculator (own panels possibel)

Victron Multiplus 3 phase system simple diagram

DIY

Palermo (B.Seesink) 3 October 2024 06:31 2

I have between the battery to the distributor an on/off switch like this
Or this one but then with a fuse is also recommended.

Greetings
Palermo

Topic		Replies	Views
Is my system good? DIY 3-phase , cerbo-gx	2	278	18 October 2024
Advise about a 3 phase system. What fuses? DIY diy , multiplus-ii , 3-phase , cerbo-gx	2	305	6 April 2025
Victron Multiplus 48/8000 Q&A and troubleshooting beginner , offgrid , busbar , multiplus-ii , cerbo-gx	12	234	22 November 2025
Fuses and cables value? DIY beginner , pv-inverter , multiplus-ii , fuses , victron_community , 3-phase , backup	4	188	6 April 2025
Impact of Unequal AC Cable Lengths on Three-Phase Victron MultiPlus-II Setup DIY beginner , multiplus , parallel , multiplus-ii , victron_community	1	176	26 July 2025

Victron Multiplus 3 phase system simple diagram

Related topics