Smart Shunt - state of charge

[pwfarnell]

If the SOC is not increasing when you charge it indicates you have not wired the shunt correctly and the charger negative is connected to the battery negative, not the shunt system negative. See the FAQ I wrote, there is also another about synchronisation settings thst you should read. Pinned topic at the top of the DIY section.

Shunt / battery monitor not reading the correct SOC/ Amps, missing solar, decreasing daily or other misreading problems

This topic covers the SOC / Amps reported by BMV battery monitors, SmartShunts, Lynx BMSs and Lynx Shunts and will just be called shunt below. It is also assumed that the shunt is monitoring the domestic / house / cabin battery bank and not engine start / bow thruster / winch / caravan mover battery banks. The problems may be one or more of the following The SOC decreases daily despite the solar charger or other charger(s) working. The SOC increasing when discharging and falling when charging…

Battery monitor jumping to 100% or reporting a high SOC with low Volts / the BMS shuts down

This topic covers the reported SOC being out of sync with the actual battery voltage or state. It covers BMV battery monitors, SmartShunts, Lynx BMSs and Lynx Shunts and will just be called shunt below. It is also assumed that the shunt is monitoring the domestic / house / cabin battery bank and not engine start / bow thruster / winch / caravan mover battery banks. The problems may be one or more of the following and is often linked to mobile applications with small solar systems. The SOC jum…