Ruuvi Tag to NMEA via Cerbo and Signal K issue

DIY
, , , , ,
1

We have got Ruuvi tag data onto NMEA networks in a number of installs, if I’m correct, all with standard Cerbos, no Cerbo 2’s. This install is a Cerbo 2.

On this particular install, we have Signal K enabled, with the Mapping and Signal K to NMEA plugins installed.

Have mapped the Ruuvi Tag data to the correct place:

image
image2285×150 98 KB

Then enabled the Signal K to NMEA Temperature PGNs required:

image
image560×879 23.6 KB

But we do not get the temp data on the NMEA network.

Any ideas?

2

Did you ever figure this out? It is amazing, there are several people that know how to do this yet the information isn’t or wont be shared so we all can benefit. Victron support is awful at best, even after spending $1000’s on their equipment. I really wish someone would post very simple, easy to follow instructions for doing this.

3

Yes, in my instance it was because the Victron VE-CAN to NMEA cable was faulty.