Hi, Í am switching from Renogy to Victron equipment for my initial off grid setup.
I have a few questions regarding the VRM interface, I’m sure these have been asked many time but was unable to find an answer.
Below is a screenshot of my system minus the mppt controller, (different question).
My system is not and will not be connected to grid or generator input so I would like to remove the icons for these from the VRM interface.
Is this possible ?, I was under the belief you can customise the VRM interface to whatever equipment you do and don’t have.
The way I initially set this up was to add installation and chose Cerbo GX and this is what it defaulted my display to, I can’t find a way of customising the layout.
System consists of 2 x 200A LiFePO4 in parallel
1 x Cerbo GX
1 x Smartsolar mppt 100:50
1 x Smartshunt
1 x Longi 450w solar panel
1 x 3000W Renogy Inverter
1 x 1000w Renogy Inverter
