Remote Console Grid and AC loads currents vastly different

DIY
, , ,
1

I have recently installed a parallel system and have two issues that probably both stem from the same thing:

  1. A scheduled charge does not stop the battery from being discharged. When on a scheduled charge the battery discharge rate is 1/2 total power consumption.

  2. On remote console the Watts and Volts are good everywhere and the Grid current is correct but the AC loads current value is twice the Grid value (actual value).

I have a CT and an ET112, I am thinking there might be a problem there but they worked very well together when it was a single multiplus.

I have watched the vids and RTFM but not able to diagnose this. Any clues ?