This topic covers the reported power in the DC system tile as shown on a Venus device (such as CCGX, Cerbo, Ekrano or Raspberry Pi etc.) or on VRM dashboard. The symptoms are typically that the DC power does not match with a calculation using the power shown and the battery, solar and ac tiles and/o…

[image] pwfarnell: “If you have a system which does not measure the DC System Power using a SmartShunt or BMV 712 (see later) then this is entirely normal.” Not sure if I’m reading your response correctly as it indicates to me that this is an issue if no Smartshunt is installed - which is not…

I am afraid you are reading it wrong. You have a SmartShunt that is measuring your battery charge and discharge current. This is explained further in the last paragraph, if you have DC loads that are not measured by Victron equipment such as DC lighting, DC pumps etc. (The DC System) then you can ad…

The DC System Power on a Venus device is jumping, erratic or does not match other loads

DIY

Topic		Replies	Views
Cerbo Dashboard "DC Power" Reading DIY diy , campervan , gx_device , cerbo_gx	1	233	March 22, 2025
VRM and DC Power feature DIY beginner , vrm , campervan , mppt_controllers	11	744	March 26, 2025
SmartShunt contribution to "DC Power" display is incorrect DIY diy , offgrid , display , cerbo_gx	15	821	June 5, 2025
DC Power on VRM Portal Q&A and troubleshooting beginner , vrm , power_meter , cerbo_gx	2	102	December 18, 2025
Direct DC loads and shunt DIY smartshunt , multiplus-ii , dc_system , cerbo_gx	24	568	December 16, 2025

The DC System Power on a Venus device is jumping, erratic or does not match other loads

Related topics