My research is failing me. I can’t seem to set my Bulk voltage on my 150/70 solar controller for my LifePo4 Battleborn batteries. Battleborn says Bulk voltage should equal Absorption of 14.4 volts. The controller charges Bulk at 13.6 volts no matter what I try. Any Ideas?

Setting Bulk voltage to 14.4

pwfarnell Split this topic 2 November 2024 08:45 10

Topic		Replies	Views
How to set charge voltages for Voltgo LiFePO4 battery with Easysolar II? DIY victronconnect , mppt_controllers , easysolar_all-in-one	4	88	28 November 2025
Charger settings for 16S LiFePo4 pack DIY diy , ess , vrm , lithium_battery	19	4123	8 September 2025
Absorb to Bulk Q&A and troubleshooting mppt_controllers	5	68	30 November 2025
Victron BSC IP65 12/15 Bulk issue Q&A and troubleshooting beginner , bluesmart_ip22	1	33	31 December 2025
MPPT stays in Bulk, not going into absorption nor float DIY victronconnect , beginner , campervan , mppt_controllers , cerbo-gx	4	543	15 May 2025