Is there any way to turn off the indicator lights on the Orion XS? I already tried putting electrical tape over the bulbs but it flashes through the body of the unit.
If not I would love to have this feature.
Sadly not. But this would be a nice feature, i also had to put tape over GXs status lights, since their blinking was visible through cabinet cracks
Iād like this too! Ideally on all Victron devices. Specifically, Iād like to be able to use VictronConnect to turn off all LED indicators unless there is a fault/error state. It would be fine for them to be on during initial power-up, but they should then go off. Think of it as ādark modeā.
Iāll pass on the request 