Question regarding charging a large lithium bank (2×200Ah 24 v) through a high output alternator on a sailboat. Does an Argofet limit the current ? Can it be used as a current limitor between alternator and lithium ? Or is orion the only / best way to go. Or is an exterbal alternator regulator. Tryi…

What is the output and voltage of the alternator? Is it / Will it be adjustable? are you still in the process of setting up the drive/generator system? You won’t be able to reach the maximum charging capacity of 0.5C anyway.

In this case It’s not about protecting the battery but about protecting the alternator against overcharging it.

Can you regulate the output voltage of the alternator? A DC/DC converter would be a good solution as protection… but it has far too little power to quickly charge a larger battery bank. An Argo FET does not protect against overcurrent … only against “back current” from other voltage sources …

Good experience here with a Wakespeed WS500 external regulator controlling a 175A alternator charging a 600Ah lithium battery bank. Limits the charge current to 120A to avoid overheating. You still have to consider load dump if the BMS shuts of charging. If the BMS has an ATC contact then that can b…

I see no AGM 24 volt from victron though.

I guess that’s the real question. Is it ok to connect an alternator with a proper external regulator directly to lithium ? Removing the buffer battery and dc-dc chargers. ? Or would you still add a small agm in parallel separated with an argofet. To absorb the eventual spike. Although something l…

Normally either External regulator direct to lithium with alternator protection and ATC Or Buffer lead acid battery and DC to DC. Victron Lynx BMS can be set up to shut down alternator before the BMS disconnects.

I would definitely recommend a DC DC charger, because your generator does not provide a suitable charging voltage for a LiFePo… the rotational speed of the engine also changes and the BMS should not be constantly responding. The Orion XS 1400 DC-DC battery charger would probably be the best choice …

I have a Balmar 100A alternator connected to a Balmar ARS-5 regulator. I will be installing a 300AH lithium house battery and keeping my lead-acid starting battery. I plan on upgrading the regulator to a Bamar MC-618, which is lithium-friendly, and connecting it directly to the lithium. The startin…

Charging large lithium bank through a high output alternator

Q&A and troubleshooting

bobbiemartin (Bobbie Martin) 14 October 2025 10:30 11

I have a RV with 660ah battery bank and Lynx BMS. It charges with a Wakespeed regulator and 160 amp Balmar alternator. The Wakespeed is connected to the Victron bus to a Cerbo. It works great. You can see it here.

Topic		Replies	Views
Charging lithium bank from DC generator and primary engine alternator with one argofet DIY marine , diy , argo_fet_diode	4	499	20 September 2024
Orion XS for outboard motor to charge LiFePO4 battery Q&A and troubleshooting marine , diy , orion_xs	6	319	4 May 2025
Alternators burning out, what are we doing wrong? DIY diy , orion_xs	11	468	22 April 2026
Overloaded alternator when charging via an Orion DC to DC charger AND a depleted starter battery? DIY marine , beginner , dc-dc_charger	5	141	6 May 2026
Dc to dc charger or cytric li ct for dumb alternator lead start batt to Lithium leisure batt DIY beginner , rv , cyrix_battery_combin	3	242	2 February 2025

Charging large lithium bank through a high output alternator

Related topics