My system is configure in DVCC mode. In the VRM BMS/Battery config, in the parameters tab page, I see the CVL value configured 57.60V (3.6V per cell). Where is this value originating from? In my JK-BMS config, I’ve NO value set to 3.6! The Vol. Cell RVC field is configured at 3.450V. [image]

Name: New JK-BMS V14 and V15 Firmware with advanced Charging Algorithm and... a new bug?🙄
Uploaded: 2025-05-20T13:47:33Z
Description: [New JK-BMS V14 and V15 Firmware with advanced Charging Algorithm and... a new bug?🙄]

Where is the JK-BMS CVL value originating from

DIY

Diessel (Diessel) 20 May 2025 13:47 10

Topic		Replies	Views
JK BMS and DVCC DIY ac_coupling , jk-bms	24	4404	6 September 2025
Multiplus forcing JK BMS into High voltage alarm while JK BMS in controll DIY vrm , dess , jk-bms	40	892	9 August 2025
Battery discharge with maximum power to the grid on CVL change from absorption to float DIY	3	261	25 March 2025
Unable to reach full charge voltage for balancing DIY parallel , bms-12-100 , multiplus-ii , victron_community , cerbo-gx	24	971	22 November 2025
Ignores discharge power to float voltage DESS beginner , ess , dess , jk-bms	111	1340	6 November 2025

Where is the JK-BMS CVL value originating from

Related topics