VRM notifier alerts since Updating to 3.75
Now happening each Time the Generator is run Only lasts a Few Seconds to a few minutes before Clearing Not had them before only occurring on 1 Install of 2 updated Ac input is Consistent & does NOT drop out.
With most VRM alarms you can set a delay time for the fault condition to remain active before the alarm sounds, so set this to say 180 secs.
Thanks
Will give that a go Presuming its the gateway as its only seconds before it restores
Now its for the full running time of the gen ONLY on 1 System
Alarm delay does Not Stop the error
This Issue continues Ac input not available on Start up (there Is Ac input)
Ac Input is inverting on Gen Stop (there is No ac input after Stop)
