# Solar yield (AC Coupled) shown as Critical loads **URL:** \ **Category:** DIY\ **Tags:** 3-phase, domestic, beginner, multi\_rs\ **Created:** [15 May 2025 11:31 UTC](https://community.victronenergy.com/t/solar-yield-ac-coupled-shown-as-critical-loads/32481 "2025-05-15T11:31:58Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![Arjan\_Renting](https://avatars.discourse-cdn.com/v4/letter/a/839c29/32.png) [@Arjan\_Renting](https://community.victronenergy.com/u/Arjan_Renting)\ **Post date:** [15 May 2025 11:31 UTC](https://community.victronenergy.com/t/solar-yield-ac-coupled-shown-as-critical-loads/32481/1 "2025-05-15T11:31:58Z")
Just got my system up and running since a couple of days. I have a 3 phase Multi RS system with SMA Inverters. In the testing phase there was no load connected to the Multi RS and Solar and House was still grid connected. Yesterday I made the switch over (1 0 2 switch) to put my system in the middle so my Solar and House are connected to AC Out 1. I have them positioned at AC Output in the config. ![image](https://europe1.discourse-cdn.com/victron/original/3X/4/e/4ee8ee86e43d6ca8c4134d80789d4fee8d801849.png) As you can see PV and Critical Load to too close to be a coincidence. 5kW from PV, 5kW into critical load, battery charging with 2kW, 2kW going to grid. What am I doing wrong? When I change the position in the configuration it simply doesn’t measure. ![image](https://europe1.discourse-cdn.com/victron/original/3X/a/8/a853ca67a39b006b6b7a7cf3c8c09007f117486c.png) ---
**Author:** ![Arjan\_Renting](https://avatars.discourse-cdn.com/v4/letter/a/839c29/32.png) [@Arjan\_Renting](https://community.victronenergy.com/u/Arjan_Renting)\ **Post date:** [15 May 2025 20:26 UTC](https://community.victronenergy.com/t/solar-yield-ac-coupled-shown-as-critical-loads/32481/2 "2025-05-15T20:26:28Z")
After a reboot of the system it started behaving normal again. ![image](https://europe1.discourse-cdn.com/victron/original/3X/b/1/b198a39a0a27d10002827dd05c038f821d794c86.png)