Setting Mppt charge controller for 2 Super Start GC110DT 6V deep-cycle batteries in Series?

DIY
, ,
1

trying to figure out best charge controller settings for my specific batteries. everyone says read the battery data sheet but somehow that doesnt seem obvious to me.

I have 2 of these in series to make 12 V system

-(Super Start GC110DT is a 6V deep cycle Batterys with a reserve capacity of 120 minutes at 75 amps and 120 minutes at 25 amps)

What are my best settings for maximum charge current, Float absortion etc. it seems like i need to go expert mode since there isnt a preset for these batteries.

Thanks

2

Use the built in preset for flooded (wet) lead acid batteries.

See Super Start Fleet And Heavy Duty Battery - Super Start Battery

Recommended is to also set the automatic equalisation for 30 - 45 days.