Lynx system in a corner

DIY
, ,
1

Hi,

I am planning a new installation in a sailboat. This would include a Lynx PowerIn (classT), a Lynx Smart BMS NG and Lynx Distributor.

My problem is that I don’t have enough room to put the 3 Lynx components in one row.

Does anyone have recommendations how to install them horizontally, but with a 90° angle between BMS and Distributor (in a corner).

My first thought was going to bent busbars (but haven’t found that easily)

Any picture of similar install would also be welcome

Thanks in advance

2

3 other ways are possible. Dont forget to match the lynx size for the amps.

  1. Flexible bus bar expensive but cool.
  2. Make cables lugged to match the bus bar
  3. Bend copper bus bar (an engineering feat) cover with heat shrink.

I have used all three. Depending on budget (and how hard i want to make my life)

3

1"x1/4" Copper busbar can be bent fairly easily - using a hammer and vice.