I see that v3.73 added SeeLevel BT integration but they do not show up under I/O

DIY
,
1

Since no response yet, did I miss understand what Victron announced for v3.73 firmware?

Anyone seen documentation on how to get them into a CerboGX? I was able to add my Ruuvi sensors a while back and after adding an external BT dongle they are now working great. My GX and Seelevel BT panel are a few feet apart but I have yet to figure out how to get my GX to see that. I checked Tanks, but those are for Physical wiring only. Under I/O I was able to add my Ruuvi Tags but the Seelevel is not showing up where I thought it should, nor anywhere else for that matter. -Bill

2

Hi,

They are added in the same way as Ruuvi sensors are added. So they need to be enabled in Settings->Integrations->Bluetooth Sensors.

With kind regards,
Thiemo van Engelen

3

My v3.73 does not have an “Integrations” option under Settings? Bluetooth Sensors choice is under Settings->I/O->Bluetooth Sensors. And my SeeLevel does not show up. I also looked while connecting to the SeeLevel via BT from my phone to see if it needed input to show up. Here is what I can see in there. -Bill

image
image747×422 55.1 KB

image
image752×412 54.6 KB

4

Hi,

I am sorry to say that we missed a detail in the difference between the SeeLeveL SOUL / 709-BTP7 and the 709-BTP3. This is causing the BTP3 to not be detected.
We have to see whether we can also add support for the 709-BTP3.

With kind regards,
Thiemo van Engelen