# High CPU useage Cerbo GX when changing I/O analogue

**URL:** <https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336>\
**Category:** DIY\
**Tags:** gx\_device, cerbo\_gx, professional, vrm\
**Created:** [30 July 2025 06:47 UTC](https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336 "2025-07-30T06:47:35Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![mewgaf](https://avatars.discourse-cdn.com/v4/letter/m/439d5e/32.png) [@mewgaf](https://community.victronenergy.com/u/mewgaf)\
**Post date:** [30 July 2025 06:47 UTC](https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336/1 "2025-07-30T06:47:35Z")

</div>

Hi all  
I have a bug in the Cerbo GX.  
I have three victron temperature sensors.  
One is going faulty (this is not the problem), I went into the I/O, analogue and disabled Temp input 2, so that I’m not seeing this input on Red Node or VRM.  
When I have done this the Cerbo GX cpu stays around 75% useage.  
If I enable this input on the Cerbo GX the CPU drops down to 35%.  
I have rebooted Cerbo GX with the same result.

---

<div class="post-metadata">

**Author:** ![nickdb](https://dub1.discourse-cdn.com/victron/user_avatar/community.victronenergy.com/nickdb/32/51440_2.png) [@nickdb](https://community.victronenergy.com/u/nickdb)\
**Post date:** [30 July 2025 07:07 UTC](https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336/2 "2025-07-30T07:07:44Z")

</div>

Do you have anything else loaded on the gx that is referencing the temperature sensor? Nodered etc?

---

<div class="post-metadata">

**Author:** ![mewgaf](https://avatars.discourse-cdn.com/v4/letter/m/439d5e/32.png) [@mewgaf](https://community.victronenergy.com/u/mewgaf)\
**Post date:** [1 August 2025 03:14 UTC](https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336/3 "2025-08-01T03:14:43Z")

</div>

As per above this temp sensor is an input to node red (set to send change only)

---

<div class="post-metadata">

**Author:** ![nickdb](https://dub1.discourse-cdn.com/victron/user_avatar/community.victronenergy.com/nickdb/32/51440_2.png) [@nickdb](https://community.victronenergy.com/u/nickdb)\
**Post date:** [1 August 2025 04:16 UTC](https://community.victronenergy.com/t/high-cpu-useage-cerbo-gx-when-changing-i-o-analogue/41336/4 "2025-08-01T04:16:09Z")

</div>

If you temporarily disable nodered but leave the sensor attached, what happens to cpu usage?
