I just updated to 2.08, and after that the EVCS didn’t connect to my wifi again.
On the display I could see it had activated the access point, and after connecting to that, it went through the initial config. All settings gone, but the display could still show the data from the last charge session.
Might want to hold off on that update, unless it intentional to mostly reset it.
Hi bei mir lief das update ohne Probleme durch. Alle Daten
noch da.
I noticed the popup of this update in the web interface too and didn’t update, because there’s no firmware version 2.08 published on Victron Professional, nor is the changelog available. Huh?
But thanks for the heads up, I’ll postpone this for now.
edit: there is a changelog posted on the FW Update page in the web interface:
It has been released today, sometimes it takes some time to update VicProf/Dropbox.
