EasySolar-II_GX and Cerbo_GX compatability

Hi

Can anyone tell me if it is possible to disable a internal gx device in a EasySolar-II_GX so that I can use a Cerbo_GX with a touch 50 instead? I have a system with 2 x 250/100 mppt’s, a smart shunt and a EasySolar-II_GX along with 4 x batteries making a 48v system. The Cerbo_GX has a starlink Ethernet connection and I can see the 2 mppt’s and the shunt but I can’t talk to the EasySolar-II_GX. It was connected to the Cerbo via a VE direct cable. Is this the correct way to connect it to the cerbo? The system is basically working but I can’t get any data out of the inverter. Any help would be appreciated. Thanks

Yes you can disable the internal gx and connect the system to cerbo gx with ve bus not ve direct

And you will have to connect the internal mppt to the cerbo with ve direct

There have been a number of “upgrades” like this to GX models over time, usually to cater for new connectivity requirements.
It isn’t sexy, but can be done.

Thanks Marc. Do you know the process to disable the internal GX? Is it listed in the manual? Can I perform those changes via VRM? Changing the cabling should be straight forward. I will ask them to do it. They are in a remote part of Vanuatu and I have returned to Australia. thanks for you help.

There is no manual, search the community, its just disconnecting the internal gx board