My current setup has no BMS connected to the victron venusos
I bought a new battery but is not connected on DC level yet and wanted to connect it via RS485 driver to Venusos. (On a RPI) This worked fine but the Multiplus didn’t correctly react to the grid setpoint I set.
I gave a low SOC alarm even after I removed the BMS devices from the config.
Even after reboot it keeps giving alarms for BMS connection lost and low battery alarm
Multiplus is in passthru. Not sure this was the case before but it doesn’t react to my grid setpoint settings and it doesn’t charge the existing battery (not connected via BMS to Venusos but just DC)