# Adjust AC input on Multiplus ii when trigger event

**URL:** <https://community.victronenergy.com/t/adjust-ac-input-on-multiplus-ii-when-trigger-event/63333>\
**Category:** DIY\
**Tags:** rv, assistants, multiplus-ii, diy\
**Created:** [29 September 2026 17:28 UTC](https://community.victronenergy.com/t/adjust-ac-input-on-multiplus-ii-when-trigger-event/63333 "2026-09-29T17:28:19Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![bfezz1](https://avatars.discourse-cdn.com/v4/letter/b/59ef9b/32.png) [@bfezz1](https://community.victronenergy.com/u/bfezz1)\
**Post date:** [29 September 2026 17:28 UTC](https://community.victronenergy.com/t/adjust-ac-input-on-multiplus-ii-when-trigger-event/63333/1 "2026-09-29T17:28:19Z")

</div>

I have a multiplus ii 2x120 in an RV with an Onan QG7000 generator. In my current set up, when on shore power, I have the multiplus set to 50 amp but when connected to the generator I need to lower that to 10 amps to prevent overloading the generator. Can I use the input current limit control assistant to automatically change the input voltage to 10 amps when the generator is running (I can just tap off the hour meter for a 12v signal).

 ![image](https://europe1.discourse-cdn.com/victron/original/3X/c/7/c7d70a40f1856578cac66b2d4bd6e542e17c5628.png)