TAB: General
System frequency	50Hz
Shore current	25.0	A
Overruled by remote	checked
Dynamic current limiter	unchecked
External current sensor connected (see manual)	checked
State of charge when Bulk finished	85.0	%
Battery capacity	450	Ah
Charge efficiency	1.00	
TAB: Grid
Country / grid code standard	New Zealand:      AS/NZS 4777.2:2015 (AC Neutral Path externally joined)
LOM detection AC input 1	Type B (grid code compliant)
TAB: AS/NZS 4777 grid code settings
rise-in-voltage protection U>	258.0	V
Power ramp time	360	seconds
Enable DRM0 functionality	unchecked
Fstop for sustained high frequency operation	52.00	Hz
Volt-Watt curve voltage V1	207.0	V
Max charge power at V1	0	%
Volt-Watt curve voltage V2	220.0	V
Max charge power at V2	100	%
Volt-Watt curve voltage V3	244.0	V
Max charge power at V2	100	%
Volt-Watt curve voltage V4	255.0	V
Max invert power at V4	20	%
Reactive power regulation	Use a fixed Cos Phi
Filter time for reactive power	3.3	s
Cos phi at point 1	1.00	
TAB: Inverter
PowerAssist	unchecked
Inverter output voltage	230	V
Inverter DC shut-down voltage	44.00	V
Inverter DC restart voltage	48.00	V
Low DC alarm level	48.00	V
Do not restart after short-circuit (VDE 2510-2  safety)	unchecked
enable AES	unchecked
TAB: Charger
Enable charger	checked
Weak AC input	unchecked
Stop after excessive bulk	unchecked
Lithium batteries	checked
Use equalization (tubular plate traction battery curve)	unchecked
Charge curve	Fixed
Absorption voltage	52.00	V
Float voltage	51.00	V
Charge current	70	A
Repeated absorption time	0.50	Hr
Repeated absorption interval	1.00	Days
Absorption time	1	Hr
TAB: Virtual switch
TAB: Usage
Virtual switch usage	Do not use VS
TAB: Assistants
TAB: Assistant Configuration
ESS (Energy Storage System) (size:1709)
*)	System uses LiFePo4 with other type BMS
	(This can be either a BMS connected via CAN bus or a BMS system in which the 
	batteries are protected from high/low cell voltages by external equipment.)
*)	The battery capacity of the system is 450 Ah.
*)	Sustain voltage 48.00 V.
*)	Cut off voltage for a discharge current of:
	0.005 C= 46.00 V
	0.25 C= 46.00 V
	0.7 C= 46.00 V
	2 C= 46.00 V
*)	Inverting is allowed again when voltage rises 1.20 V above cut-off(0).
*)	The solar converter will start reducing its output power at 50.20 Hz.
	Output power will be reduced to minimum when the frequency is  52.70 Hz.
	The converter will disconnect when the frequency is higher than  53.00 Hz.
*)	Total installed PV inverter power is 5000 Watts.
	Total installed PV panel power is 5580 Watts.
*)	Relevant VEConfigure settings:
	  -  Battery capacity 450 Ah.
	  -  PowerAssist unchecked
	  -  Lithium batteries checked
	  -  Dynamic current limiter unchecked
	  -  Storage mode unchecked

generator start and stop (size:184)
*)	Use primary programmable relay to start generator.
*)	Close relay to start generator.
*)	Start generator when the state of charge is lower than 35 %.
*)	Stop generator when state of charge is higher than 80 %.
*)	The generator is not stopped by AC input.


Total size of all assistants including the required
(hidden) system assistants is: 1973