I have a Cerbo GX connected to an Elecrow 5" HDMI Touchscreen Monitor through an HDMI switch which allows the display output to be switched between the GX and a couple of other systems.
The whole thing works pretty well except in this one respect.
I am able to configure the two non-VenusOS systems to power down the display a short time after user interaction dries up and power up again when the sleeping display is touched.
I have been wondering how to achieve this behaviour under VenusOS. I'm not even sure if this type of screen saving is implemented for the GX Touch 50 - I haven't played with one and the manual doesn't say - if it is then some digging might reveal a solution.
Any ideas or confirmation of GX Touch 50 behaviour would be much appreciated.
