question

saabjoakim avatar image
saabjoakim asked

Color control GX setup for Panda Fischer Generators

What can bus profile shall be used for detecting a Panda Fischer generator with xControl with the Colour Control GX?


/Joakim

CCGX Color ControlGenerator
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
Mark avatar image
Mark answered ·

There is a dedicated instruction manual that includes all the setup requirements to connect a Fischer Panda generator to a CCGX;

https://www.victronenergy.com/live/ccgx:fischer_panda

The NMEA2000 CAN Bus profile should be selected.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

saabjoakim avatar image
saabjoakim answered ·

Thanks. Would you please complete with can bus profile, to be set in the Victron Colour Control. That is not found in the instruction.

1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Mark avatar image Mark ♦♦ commented ·

Hi @saabjoakim I just updated the answer and Victron have just added this info into the online manual.

0 Likes 0 ·
saabjoakim avatar image
saabjoakim answered ·

Sorry, I don't find that. The profiles in the module are (found under Services -> CAN bus profile):

VE.CAN & Lynx ION BMS (250 kbaud)

VE.CAN & CAN-bus BMS (250 kbaud)

CAN-bus BMS (500 kbaud)

Oceanvolt (250 kbaud)


Firmware version v2.18


The xControl unit from Panda is configured for J1939, producing 3 fast blinks and then pause on the diagnostic led. This unit is working, since it recently was there for configuration.

1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Mark avatar image Mark ♦♦ commented ·

That's fairly old firmware in the CCGX, could you try to update to the latest FW release and then check again?

0 Likes 0 ·